Whirlpool Dishwasher Not Cleaning? The “Grit on Glasses” Fix.

Disclaimer: Dishwashers are full of broken glass and bacteria. Wear gloves. Turn off the breaker before you touch anything.

The Symptom: You open the door, expecting sparkling dishes. Instead, your cups on the top rack are filled with sandy grit, and the plates look like they were licked by a dog, not washed. The Lie: “You need better detergent.” The Truth: Your food chopper assembly has failed. It’s a mechanical heart attack.


The Whirlpool Dishwasher Not Cleaning Diagnostics: Is It the Chopper or the Valve?

Before you buy parts, listen to the machine.

  • Scenario A: The “Grit” Bomb. If the machine fills with water and sprays but leaves sand/grit on dishes, your chopper assembly is dead. The screen is clogged, starving the spray arms of water pressure.
  • Scenario B: The “Dry” Run. If the dishes are bone dry and dirty, your water inlet valve isn’t opening.
  • Scenario C: The “Filter” Clog (Newer Models). If you have a newer Whirlpool/KitchenAid (post-2015) without a hard food disposer, your manual filter is just clogged. Pull the bottom rack and twist out the tube. Clean it.

The Fix: Replacing the Chopper Assembly (W10083957)

This applies to millions of Whirlpool, KitchenAid, and Kenmore “Ultrawash” models.

The Part: [Whirlpool W10083957 Chopper Assembly].

  • Why it fails: The tiny plastic drive shaft snaps inside the blade. The motor spins, but the blade doesn’t. The screen plugs up with jar labels and popcorn kernels.

The Surgery:

  1. Empty the Tub: Remove the bottom rack.
  2. Remove Spray Arm: Twist the nut on the bottom spray arm (lefty-loosey) and lift it out.
  3. The “Trap Door”: Remove the screws holding the filter cover (the grey plastic tunnel in the back).
  4. The Reveal: You will see a  round white screen. That is the cover. Remove the one screw holding it.
  5. The Swap: Pull the old chopper out.
    • Check: Look at the old one. I bet you $10 the screen is 100% blocked with gunk or the internal spring is broken.
  6. Install: Slide the new one in. It must sit firmly on the motor shaft.
  7. Reassemble.

Cost: ~$35. Repairman Quote: $250.


The “Low Water” Fix: Inlet Valve (WPW10327249)

If your chopper is fine, but the top rack isn’t spinning, you likely have low water pressure. The inlet valve screen gets clogged with calcium.

The Part: [Whirlpool WPW10327249 Inlet Valve].

  • Location: Behind the bottom kickplate, on the left side (where the hose connects).
  • The Fix: Two screws, one wire harness, and one hose. 15 minutes.

Maintenance: The “Affresh” Protocol

Once you fix the part, you need to dissolve the calcium that killed it. The Habit: Run an [Affresh Dishwasher Cleaner] tablet once a month.

Need Tools? You will need a T20 Torx driver for those internal screws. Don’t strip them with an Allen key. Get the [Frugal Fix Toolkit].

Leave a Comment